TALR-20NC Automatic Door Lite Router

Automatic door lite and lock cutout machine for metal, fiberglass and wood door slabs. The machine operates by two servo drives and is controlled via 7" touch screen. The door enters the machine via automatic feed system.

Once the slab is clamped, automatic recognition system tells the machine exact width of the door. This is done to keep the lite opening in the center of the door. The operator then selects the cutout by entering three dimensions of the rectangular cutout and two more codes for the lock and deadbolt holes.

All other shapes are pre-programmed by Vega technicians. Once the "start" soft key is pressed machine goes to cycle which lasts approximately 90 seconds

If lock and deadbolt holes were selected the machine cuts the out first and then moves to cut the lite opening. At the same time another motor advances to bore 1" hole on the edge of the door for the handle and deadbolt.

After the cycle is complete, an optional blow off system cleans the door from the chips. The finished door can be transferred in any direction, either back to the tilting station or forward to the next workstation.